Operation
Operating manual 100-69 version 00.0 - 05/2013
39
Fig. 24: Message display
2. Press the EMERGENCY-stop (1).
If the transport clamps are not at the reference position, a reference run
is made.
5.9.2 Reference position
The reference position is necessary to reach a defined initial position.
When the sewing unit is switched on, the control checks whether the trans-
port carriage is in its rear end position.
If this is not the case, the display shows the following message:
Fig. 25: Message display
Danger of being crushed!
Do not reach between the folder and the folding ta-
ble!
WARNING
Comments to this Manuals